澳门新葡新京官方网站-葡京网址官方网址

Product Matching device

Single screw pump skid system

Single screw pump skid system

Contact Us

Product Details

Brief introduction

Single screw pump is an important fluid conveying equipment. It is widely used in various industrial processes, also known as eccentric screw pump, G-type screw pump or electric single screw pump, because it is not only suitable for medium with low viscosity such as water, but also for suspension with solid particles or short fibers, and medium with very high viscosity.

Xinglong single screw pump is a kind of positive displacement pump, through the meshing pairs (stator and rotor) between the closed formation of a certain geometry cavity to transport liquid. The material of pump overflow parts is determined according to the specific characteristics of fluid materials transported.

The skid mounted system of single screw pump is designed to connect the pipes and connecting lines in advance when they leave the factory, and then to use the client to directly connect the transmission pipeline and power supply. Skid mounted design is compact, with rack, pipeline, flowmeter, pressure reducing valve, pressure gauge, etc. it can be equipped with control system, and can input all operation parameters in advance, including alarm information. Optional including PID controller and electrical switch.

The screw pump skid system allows several pumps to share a base. When a pump fails, the standby pump can be switched to use without shutdown. The pump is compact in design and suitable for the mixed transportation of materials with solid content of 20% or less.

澳门新葡新京官方网站撬装系统.png

Advantages

The standby pump can be started immediately in case of failure, and there is no need to connect another pipeline in an emergency

Media will not be agitated, squeezed or sheared during pumping

The conveying capacity is directly proportional to the rotating speed, and the conveying capacity can be adjusted by frequency conversion, with high precision metering conveying

efficient

All liquids can be pumped with minimal agitation and pulsation

All operation parameters and alarm information can be monitored, and system fault handling scheme can be preset in advance


For you to solve transport requirements include

Full series of standardization, the maximum flow can reach 300 m3 / h

Output pressure up to 48 bar

Different materials can be used for overflow metal parts, from tool steel to nickel / chromium steel, high acid resistant materials such as duplex stainless steel, Hastelloy and titanium alloy

Different stator rubbers are used, such as NBR, EPDM, CSM, PTFE, FPM and HNBR.

Allow several pumps to share a base

Optional including PID controller and electrical switch

Standby pump can be started immediately in case of failure


Strict quality standards and test procedures ensure that you get the best performance screw pump. We continue to provide after-sales technical support (4008055600) to ensure the best performance under various service conditions.



XML 地图 | Sitemap 地图